HP Model 748 HP Model 748 Service Handbook - Page 65
Selecting Device Address, Procedure
View all HP Model 748 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Removing and Replacing Mass Storage Devices Selecting Device Address Procedure 1 Unpack the device. 2 Set only jumpers or switches that are required to change the device SCSI address, any others should remain as shipped. The default SCSI addresses for devices is shown in Table 5-6. You should check the address as set on the failing drive and set the address on the new drive to the same value. Table 5-6 Default SCSI Addressing 1st Hard Disk Drive ID 6 2nd Hard Disk Drive ID 5 3rd Hard Disk Drive ID 4 DDS Drive ID 3 CD-ROM Drive ID 2 Floppy Drive ID 0 5-17
Removing and Replacing Mass Storage Devices
5-17
Selecting Device Address
Procedure
1
Unpack the device.
2
Set only jumpers or switches that are required to change the device SCSI address, any
others should remain as shipped.
The default SCSI addresses for devices is shown in Table 5-6. You should check the
address as set on the failing drive and set the address on the new drive to the same
value.
Table 5-6
Default SCSI Addressing
1st Hard Disk Drive
ID 6
2nd Hard Disk Drive
ID 5
3rd Hard Disk Drive
ID 4
DDS Drive
ID 3
CD-ROM Drive
ID 2
Floppy Drive
ID 0