HP Model 748 HP Model 748 Service Handbook - Page 76
Mass Storage Device Removal, Procedure, Power & SCSI cables, Retaining screws, Device removal
![]() |
View all HP Model 748 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Mass Storage Device Removal NOTE: When replacing a floppy disk drive, you may need to add or replace a bezel. Procedure Power & SCSI cables • Disconnect both the power and SCSI cables connected to the device. Retaining screws • Loosen the four screws holding the device in the tray. Device removal 1 Slide screw heads towards large end of keyholes, remove device (see Figure 5-17). 2 Transfer screws and shoulder bushings to new device. Figure 5-17 Mass Storage Device Removal 5-28
![](/manual_guide/products/hewlettpackard-model-748-hp-model-748-service-handbook-c86c02d/76.png)
5-28
Mass Storage Device Removal
NOTE:
When replacing a floppy disk drive, you may need to add or replace
a bezel.
Procedure
Power & SCSI cables
•
Disconnect both the power and SCSI cables connected to the device.
Retaining screws
•
Loosen the four screws holding the device in the tray.
Device removal
1
Slide screw heads towards large end of keyholes, remove device (see Figure 5-17).
2
Transfer screws and shoulder bushings to new device.
Figure 5-17
Mass Storage Device Removal