HP Model 748 HP Model 748 Service Handbook - Page 85
Power Distribution PCA, Removing the Power Distribution PCA from the Wall
View all HP Model 748 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Power Supply and Chassis Parts Replacement Power Distribution PCA 1 Remove the EISA and VME card cages following the procedures given in this chapter. 2 Remove both power supplies following the procedures given in this chapter. 3 As shown in Figure 5-21, loosen the thumb screw, then slide the power distribution PCA connector (located on wall assembly) down to disconnect from wall. Figure 5-21 Removing the Power Distribution PCA from the Wall 5-37
Power Supply and Chassis Parts Replacement
5-37
Power Distribution PCA
1
Remove the EISA and VME card cages following the procedures given in this chapter.
2
Remove both power supplies following the procedures given in this chapter.
3
As shown in Figure 5-21, loosen the thumb screw, then slide the power distribution
PCA connector (located on wall assembly) down to disconnect from wall.
Figure 5-21
Removing the Power Distribution PCA from the Wall