HP NetServer AA 4000 HP Netserver AA 6200 Solutions Release Notes v4.0 SP1 - Page 12

Optional Endurance Kit Contents for 10 Kilometer SplitSite Configurations If you have purchased the support for long distance SplitSite configurations of up to10 kilometer separation of the tuples, the content of your Endurance kit is different from that described in the Release 4.0 HP Netserver AA Solution Installation Guide. Note: If you have not purchased the optional long distance SplitSite product, the content of your Endurance kit is as described in the Release 4.0 HP Netserver AA Solution Installation Guide. For long distance SplitSite installations only, the Endurance Accessory Kit includes two loopback plugs to be used if you want to perform BIOS loopback tests. On page 1-14 of the Release 4.0 HP Netserver AA Solution Installation Guide, replace the section Unpacking Your Endurance Server Kit with the following section applicable to long distance SplitSite configurations. Changes from the previous version are shown in bold face. Unpacking Your Endurance Server Kit After Planning the SCSI Disk and CD-ROM Configurations, unpack your Endurance server kit and make sure that you receive: Table 6 Endurance Server Kit Contents Quantity 4 4 1 1 1 Part MICs (Marathon Interface Cards) MIC cables -2 local and 2 remote Two fiber optic cables are 5 meters, and two are 10 meters* in length. * The 10 meter cables are used in long distance SplitSite installation for staging purposes only. IL (IOP Link) cable - Category 5 UTP cross-over (Ethernet) cable for use in fast Ethernet connections, approximately 8 meters in length IL (IOP Link) fiber - Multimode* fiber for use in gigabit Ethernet, 8 meters in length Note: You use either of the above Ethernet connections, depending on whether you have fast Ethernet or gigabit Ethernet. * The multimode fiber is used in long distance SplitSite installations for staging purposes only. Endurance CD-ROM 8 Endurance Release Notes for Release 4.0 Service Pack 1