HP ProLiant ML10 HP ProLiant ML10 Server User Guide - Page 32
Optical drive option
View all HP ProLiant ML10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
c. Connect the fan cable to the system board. 23. Install the front bezel (on page 14). 24. Install the access panel (on page 14). 25. Return the server to an upright position. 26. Connect the power cord to the server. 27. Connect the power cord to the power source. 28. Press the Power On/Standby button. The server exits standby mode and applies full power to the system. The system power LED changes from amber to green. Optical drive option 1. Press the Power On/Standby button. The server powers down and enters standby mode. The system power LED changes from green to amber. Power is still applied to the server. 2. Disconnect the power cord from the power source. 3. Disconnect the power cord from the server. Hardware options installation 32
Hardware options installation 32
c.
Connect the fan cable to the system board.
23.
Install the front bezel (on page
14
).
24.
Install the access panel (on page
14
).
25.
Return the server to an upright position.
26.
Connect the power cord to the server.
27.
Connect the power cord to the power source.
28.
Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
Optical drive option
1.
Press the Power On/Standby button.
The server powers down and enters standby mode. The system power LED changes from green to
amber. Power is still applied to the server.
2.
Disconnect the power cord from the power source.
3.
Disconnect the power cord from the server.