HP Slate 8 Pro 7600us HP Slate8 Pro Maintenance and Service Guide - Page 20
Display panel cable, Reverse this procedure to install the back cover.
View all HP Slate 8 Pro 7600us manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Remove the back cover: 1. Place the tablet on a flat surface, display panel side up, with the SIM slot and SD Card slot toward you. 2. Insert a thin, plastic tool (1) between the back cover and the display panel assembly. The first insertion point should be in the top edge of the tablet away from the power button and microphone area. CAUTION: When inserting the plastic tool into the tablet as described in Step 2, make sure not to insert the tool into the power button (2) or microphone (3) areas. Failure to follow this caution can result in damage to the tablet. 3. Lift the top edge of the back cover (4) until it separates from the display panel assembly. 4. Remove the back cover (5). Reverse this procedure to install the back cover. Display panel cable Description Display panel cable Spare part number 743832-001 Before removing the display panel cable, follow these steps: 1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system. 2. Disconnect the power from the tablet by unplugging the power cord from the tablet. 14 Chapter 5 Removal and replacement procedures