HP Spectre Pro x360 Maintenance and Service Guide - Page 38
Remove the system board, Lift the front edge system board
View all HP Spectre Pro x360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
9. Release the ZIF connector (5) to which the card reader board cable is attached, and then disconnect the card reader board cable from the system board. 10. Remove the Phillips PM2.0×2.6 broad head screw (1) and the Phillips PM2.0×2.7 screw (2) that secure the system board to the top cover. 11. Lift the front edge system board (3) until it rests at an angle. 12. Remove the system board (4) by sliding it up and forward at an angle. Reverse this procedure to install the system board. 32 Chapter 5 Removal and replacement procedures
9.
Release the ZIF connector
(5)
to which the card reader board cable is attached, and then
disconnect the card reader board cable from the system board.
10.
Remove the Phillips PM2.0×2.6 broad head screw
(1)
and the Phillips PM2.0×2.7 screw
(2)
that secure
the system board to the top cover.
11.
Lift the front edge system board
(3)
until it rests at an angle.
12.
Remove the system board
(4)
by sliding it up and forward at an angle.
Reverse this procedure to install the system board.
32
Chapter 5
Removal and replacement procedures