HP Spectre Ultrabook 14-3200 HP Spectre Ultrabook PC Maintenance and Service G - Page 67
One Phillips PM2.0×5.7
View all HP Spectre Ultrabook 14-3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
4. Remove the following screws that secure the system board to the base enclosure: (1) Five Phillips PM2.0×3.8 (2) Four Phillips PM2.0×4.6 (3) One Phillips PM2.0×5.7 5. Lift the right side of the system board (1) until it rests at an angle. 6. Disconnect the power connector cable (2) from the system board. 7. Remove the system board (3) by sliding it up and to the right at an angle. Reverse this procedure to install the system board. Component replacement procedures 59
4.
Remove the following screws that secure the system board to the base enclosure:
(1)
Five Phillips PM2.0×3.8
(2)
Four Phillips PM2.0×4.6
(3)
One Phillips PM2.0×5.7
5.
Lift the right side of the system board
(1)
until it rests at an angle.
6.
Disconnect the power connector cable
(2)
from the system board.
7.
Remove the system board
(3)
by sliding it up and to the right at an angle.
Reverse this procedure to install the system board.
Component replacement procedures
59