HP Spectre Ultrabook 14-3200 HP Spectre Ultrabook PC Maintenance and Service G - Page 70
with the processor heat sink and system board spare part kits.
View all HP Spectre Ultrabook 14-3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
NOTE: When replacing the heat sink, be sure to remove the fans from the defective heat sink and replace them on the replacement heat sink. See Fan on page 55 for fan removal and replacement instructions. Remove the processor heat sink: 1. Following the 1, 2, 3, 4 sequence stamped into the processor heat sink, loosen the four captive Philllips screws (1) that secure the processor heat sink to the system board. 2. Remove the processor heat sink (2). NOTE: Due to the adhesive quality of the thermal material located between the processor heat sink and processor, it may be necessary to move the processor heat sink from side to side to detach it. The thermal material must be thoroughly cleaned from the surfaces of the processor heat sink and the processor each time the processor heat sink is removed. Replacement thermal material is included with the processor heat sink and system board spare part kits. NOTE: The following illustration shows the replacement thermal material locations. Thermal paste is used on the processor (1) and the processor heat sink section (2) that services it. 62 Chapter 4 Removal and replacement procedures