HP StorageWorks 4/64 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 413
Enables McDATA Open Fabric mode IM3. All three operands are functionally
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 413 highlights
interopMode 2 Notes Operands The interopMode command must be executed on all Brocade switches in the fabric. Certain restrictions apply when changing Fabric Modes. Refer to the Fabric OS Administrator's Guide for more information. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. This command has the following operands: --show Displays the current interop mode settings. --help Displays the command usage. --disable Disables interop mode. This command effectively returns the switch to Brocade Native mode (IM0). --enable Enables and configures the specified interop mode settings. The following operands are supported with this option: -mcdata | -IM2 | -im2 Enables McDATA Fabric mode (IM2). All three operands are functionally equivalent. -defaultzone |-safezone Enables default zoning or safe zoning. These operands are exclusive and are valid only in McDATA Fabric mode (IM2). McDATA Default Zone and McDATA Safe Zone are fabric-wide features. If one of these features is enabled on one switch, it must be enabled on all other switches. Otherwise the E_Port is segmented. Use the cfgmcdtMode command to enable or disable the zoning features fabric wide. -openmcdata | -IM3 | -im3 Enables McDATA Open Fabric mode (IM3). All three operands are functionally equivalent. -domainoffset domain_offset Specifies the domain offset. The following domain offset values are supported in both McDATA Fabric mode (IM2) and McDATA Open Fabric mode (IM3): 0x00, 0x20, 0x40, 0x60, 0x80, 0xA0 and 0xC0. If a domain offset is not specified, the default of 0x60 is used. To enable the 239 domain mode, specify a domain offset value of 0xFF. This mode is valid only in McDATA Open Fabric Mode (IM 3). The following command options are retained for legacy reasons only. They cannot be combined with any of the options described above. mode Specify 0 to disable interoperability mode. Specify 2 to enable McDATA Fabric mode. Specify 3 to enable McDATA Open Fabric mode Available only in IM2: -z Default Zone Specify 1 to enable the McDATA default zone feature. Specify 0 to disable the McDATA default zone feature. Fabric OS Command Reference 383 53-1001337-01