HP StorageWorks 4/64 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 688
portLedTest, count, itemlist, Using Fabric OS commands, Command, Availability
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 688 highlights
2 portLedTest portLedTest Synopsis Cycles user port LEDs. portledtest [-npass count][-ports itemlist] Description Use this command to exercise the user port LEDs in the current switch on and off by setting the ATTN LEDs to green for the ON condition and unlighted for the OFF condition. The SPEED LEDs are initially set to black before the command execution. The SPEED LEDs are set to green once the command is executing. You must disable the current switch (using the switchDisable command) before running this command. After the command has completed, the ATTN LEDs flash amber, indicating that the command has finished and exited. You can enable the current switch (using the switchEnable command) to set the ATTN LEDs back to black. Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. This command is retained for legacy reasons only and is longer supported on most current platforms. On some of the unsupported platforms, the command may return a "not applicable to this platform" message. On some switches, the command is still allowed to run, but may not run without errors. Operands This command has the following operands: -npass count Specify the number of times to perform this test. The default value is 10. -ports itemlist Specify a list of user ports on which to run the test. If omitted, all the active ports in the switch are assumed. For more information, refer to the itemList command. Examples To test port LEDs: switch:admin> portledtest -ports 1/1-1/5 passed. See Also itemList, switchDisable, switchEnable 658 Fabric OS Command Reference 53-1001337-01