HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch Command Line - Page 215
set port, Table 45 Transmission speed parameters, Table 46 Port administrative state parameters
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
set port Description Sets port state and speed for the specified port temporarily until the next switch reset or new configuration activation. This command also clears port counters. Authority Admin session Syntax set port clear or set port [port_number] clear speed [transmission_speed] state [state] Operands [port_number] Specifies the port. Ports are numbered beginning with 0. clear Clears the counters on all ports or the port given by [port_number]. speed [transmission_speed] Specifies the port transmission speed. Table 45 describes the transmission speed parameters. Table 45 Transmission speed parameters Parameter 2Gb/s 4Gb/s 8Gb/s Auto Description The port speed is 2 Gb/s. The port speed is 4 Gb/s. The port speed is 8 Gb/s. The port speed is automatically detected. state [state] Specifies the port administrative state. Table 46 describes the port administrative state parameters. Table 46 Port administrative state parameters Parameter Online Offline Diagnostics Down Description Activates and prepares the port to send data Prevents the port from receiving signal and accepting a device login Prepares the port for testing and prevents the port from accepting a device login Disables the port by removing power from the port lasers See also show port, page 265 8/20q Fibre Channel Switch Command Line Interface Guide 215