HP StorageWorks SB40c HP StorageWorks SB40c Storage Blade User Guide (433904-0 - Page 16

Hardware options installation, Hard drive options, SAS and SATA hard drive guidelines

Get HP StorageWorks SB40c - Storage Blade PDF manuals and user guides View all HP StorageWorks SB40c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Hardware options installation In this section Hard drive options ...16 Hard drive options The SB40c supports up to six SAS or SATA hard drives. Always populate hard drive bays starting with the lowest device number. SAS and SATA hard drive guidelines When adding hard drives to the SB40c, observe the following general guidelines: • Install hard drives in in the lowest-numbered available hard drive bay. • To provide the greatest storage space efficiency when drives are grouped together in the same drive array, drives must be the same capacity . NOTE: ACU does not support mixing SAS and SATA drives in the same logical volume. SAS or SATA hard drive This procedure describes first-time installation only. Removing the SB40c is not necessary for subsequent drive installation. CAUTION: To prevent improper cooling and thermal damage, do not operate the SB40c unless all bays are populated with either a component or a blank. 1. Remove the hard drive blank. Hardware options installation 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
Hardware options installation 16
Hardware options installation
In this section
Hard drive options
.................................................................................................................................
16
Hard drive options
The SB40c supports up to six SAS or SATA hard drives. Always populate hard drive bays starting with the
lowest device number.
SAS and SATA hard drive guidelines
When adding hard drives to the SB40c, observe the following general guidelines:
•
Install hard drives in in the lowest-numbered available hard drive bay.
•
To provide the greatest storage space efficiency when drives are grouped together in the same drive
array, drives must be the same capacity .
NOTE:
ACU does not support mixing SAS and SATA drives in the same logical volume.
SAS or SATA hard drive
This procedure describes first-time installation only. Removing the SB40c is not necessary for subsequent
drive installation.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the SB40c unless all
bays are populated with either a component or a blank.
1.
Remove the hard drive blank.