HP Stream 11-aa000 Maintenance and Service Guide - Page 44
Remove the three Phillips M2.0×3.0 screws
View all HP Stream 11-aa000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
3. Remove the two Phillips M2.0×3.0 screws (3), and then remove the board from the holder (4). 4. If you need to remove solid-state drive holder, lift the system board ZIF connector (1) and disconnect the solid-state drive board cable (2). 5. Remove the three Phillips M2.0×3.0 screws (3), and then remove the holder from the computer (4). Reverse this procedure to install the solid-state drive and hardware. 36 Chapter 5 Removal and replacement procedures
3.
Remove the two Phillips M2.0×3.0 screws
(3)
, and then remove the board from the holder
(4)
.
4.
If you need to remove solid-state drive holder, lift the system board ZIF connector
(1)
and disconnect
the solid-state drive board cable
(2)
.
5.
Remove the three Phillips M2.0×3.0 screws
(3)
, and then remove the holder from the computer
(4)
.
Reverse this procedure to install the solid-state drive and hardware.
36
Chapter 5
Removal and replacement procedures