HP Stream 13-c000 Maintenance and Service Guide - Page 50
USB/card reader board, Disconnect the cable from the system board
View all HP Stream 13-c000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
USB/card reader board Description USB/card reader board for use in models without WWAN (includes cable) USB/card reader board for use in models with WWAN (includes cable) Spare part number 792778-001 792769-001 Before removing the USB/card reader board, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the keyboard/top cover (see Keyboard/top cover on page 29). 5. Remove the battery (see Battery on page 41). 6. Remove the WWAN/GPS module (see WWAN/GPS module on page 39). Remove the USB/card reader board: 1. Disconnect the cable from the system board (1). 2. Remove the three Phillips PM2.0×3.0 screws (2) that secure the USB/card reader board to the computer. 3. Rotate left side of board up and pull it toward the left to remove it from connectors, and then remove the board from the computer (3). Reverse this procedure to install the USB/card reader board. 42 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts