HP Surestore Tape Library Model 6/100 Hardware Operator's Guide - Page 32

Setting Cleaning Cartridge Count

Get HP Surestore Tape Library Model 6/100 PDF manuals and user guides View all HP Surestore Tape Library Model 6/100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Hardware Operator's Guide Setting Cleaning Cartridge Count Drives might occasionally require cleaning to prevent read/write errors. The drives are cleaned with a special cleaning cartridge. After a specified number of uses, the cartridge must be replaced. If your LSM was configured during installation to have the AUTO CLEAN feature enabled, you can use the LSM operator panel to set the maximum number of times a cartridge can be used. The DLT Tape Drive Product Manual suggests that you use a DLT cleaning cartridge about 20 times. You can use the View Config section of Figure 2-4 to determine whether the feature is enabled. Refer to Figure 2-2 and Figure 2-4 to set the count. 2-6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
Hardware Operator’s Guide
2–6
Setting Cleaning Cartridge Count
Drives might occasionally require cleaning to prevent read/write errors. The drives
are cleaned with a special cleaning cartridge. After a specified number of uses, the
cartridge must be replaced.
If your LSM was configured during installation to have the AUTO CLEAN feature
enabled, you can use the LSM operator panel to set the maximum number of times
a cartridge can be used.
The DLT Tape Drive Product Manual suggests that you
use a DLT cleaning cartridge about 20 times.
You can use the View Config section of Figure 2–4 to determine whether the
feature is enabled.
Refer to Figure 2–2 and Figure 2–4 to set the count.