HP Tc4100 Hewlett-Packard VA 7100/7400 Microsoft Cluster Services Installation - Page 40

Completing the Create Partition Wizard, Finish, Pause

Get HP Tc4100 - Server - 256 MB RAM PDF manuals and user guides View all HP Tc4100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

VA 7100/7400 Cluster Installation Guide 15. In the Completing the Create Partition Wizard window that appears as shown below, review the entered selections to verify accuracy. If required, click Back and make corrections as necessary. Then, click Finish to create and format the Content partition. NOTE The formatting time will vary with the Content partition size being created. NOTE The following step is necessary for configuration of the dedicated Ethernet interconnect (private) network (refer to step 2 of this procedure). Refer to Microsoft Knowledge Base article Q242430 for more information. 16. At this time, turn on node 2 power and strike the Pause key on the keyboard when the controller begins initiating. Leave node 2 in the Pause state. NOTE Do not perform any further node 2 operations until specifically instructed in chapter 7 because both nodes cannot simultaneously access the external storage array before cluster service has been installed, configured, and is up and running. 17. Continue with node 1 configuration by proceeding to Chapter 6, Cluster Setup. 10/12/01 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
VA 7100/7400 Cluster Installation Guide
10/12/01
37
15. In the
Completing the Create Partition Wizard
window that appears as shown below, review the entered
selections to verify accuracy.
If required, click
Back
and make corrections as necessary.
Then, click
Finish
to
create and format the Content partition.
NOTE
The formatting time will vary with the Content partition size being created.
NOTE
The following step is necessary for configuration of the dedicated Ethernet interconnect (private)
network (refer to step
2
of this procedure).
Refer to Microsoft Knowledge Base article Q242430
for more information.
16.
At this time, turn on node 2 power and strike the
Pause
key on the keyboard when the controller begins
initiating.
Leave node 2 in the
Pause
state.
NOTE
Do not perform any further node 2 operations until specifically instructed in chapter 7 because both
nodes cannot simultaneously access the external storage array before cluster service has been
installed, configured, and is up and running.
17.
Continue with node 1 configuration by proceeding to Chapter 6, Cluster Setup.