HP Vectra VL800 hp vectra vl800, upgrade and installation guide for desktop mo - Page 31
Cables and Connectors (SCSI Models)
View all HP Vectra VL800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
2 Installing and Replacing Hardware Parts in Your PC Installing Mass Storage Devices Cables and Connectors (SCSI Models) 16-bit SCSI Terminator fitted on cable 16-bit Internal U160 68-pin SCSI connector 16-bit SCSI cable with three 68-pin connectors IDE data cable with two connectors for optical drives External 68-pin SCSI connector (two screws) accessible from the rear of the PC. Cable with one 34-pin connector for 3.5-inch Floppy Disk Drive SCSI Card in PCI Slot Secondary IDE Connector Floppy Disk Drive Connector Primary IDE Connector Which SCSI Connectors to Use Models with a SCSI card can be connected to up to three internal SCSI devices. Additional devices can be added outside the PC by connecting directly to the rear panel SCSI connector. The SCSI card allows up to 15 devices to be connected, three internal and 12 external SCSI devices. NOTE The total length of the external SCSI cables should not exceed 3 meters (approximately 10 feet). Before Installing a SCSI Hard Disk (Selected Models Only) If you are installing an additional SCSI drive, you should configure an unused SCSI ID to this accessory. SCSI IDs range from 0 to 15 for Ultrawide 16-bit SCSI. SCSI ID 0 is used by the first SCSI hard disk drive and SCSI ID 7 is reserved for the integrated SCSI controller (the default for narrow and wide SCSI devices). You should assign an unused SCSI ID to the second SCSI hard disk drive (for example, SCSI ID 1). 31