HP Vectra VL800 hp vectra vl800, upgrade and installation guide for desktop mo - Page 39
Replacing the Hard Drive Bay and Speaker Assembly, Removing the Assembly
View all HP Vectra VL800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
2 Installing and Replacing Hardware Parts in Your PC Replacing the Hard Drive Bay and Speaker Assembly Replacing the Hard Drive Bay and Speaker Assembly Removing the Assembly 1 Switch off the display and PC. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC's cover and front bezel (refer to page 25 for these instructions). 3 Remove the two primary hard disk retaining screws located on the front left side of the chassis and lift the primary hard disk drive out of the hard disk drive bay. ➌ 4 Disconnect the data and power cables from the primary hard disk drive. If you have a second hard disk drive installed, disconnect its data and power cables. 5 Remove the two secondary disk tray retaining screws located on the front centre of ➎ the chassis, then slide the tray towards the rear of the PC and remove it. 6 Disconnect the speaker and control panel cables from their connectors on the system board. 39