HP j6700 hp workstation J6700 upgrade instructions (a6056-90000) - Page 3
Getting Started
View all HP j6700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
1 Getting Started The following important information must be adhered to for proper removal and replacement of all Hewlett-Packard parts. CAUTION This upgrade process should be performed by experienced hardware users only. Safety Warnings WARNING Removing the device cover may expose sharp edges in the equipment chassis. To avoid injury, use care when installing customer add-on devices. NOTE Before performing removal/replacement procedures, position the workstation on a cushioned flat, stable surface, such as a table top or workbench. NOTE Installing the recommended HP replacement part in your J6700 workstation does not affect the regulatory and safety classifications or approvals listed in the original owner's guide. Electrostatic Discharge (ESD) Precautions To prevent damage to the J6700 workstation, observe all of the following ESD precautions while performing removal and replacement procedures: • Remove all ESD-generating materials from the work area in which you will remove and replace the workstation field replaceable unit(s). • Open the ESD materials provided with the replacement part kit. Unfold the black conductive sheeting (antistatic mat) and place it under a corner of the workstation. • Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your body to ground. Attach the static-grounding wrist strap by following the instructions on the package. Attach the sticky end of the wrist strap to bare metal on the rear panel of the workstation. • Connect all equipment together, including the static-free mat, static strap, clips attached to the wrist strap, and peripheral units. 3