HP m9040n Getting Started Guide - Page 15

7 Click Browse to select a place to save your files, and then click OK. 8 Click Filename to specify a file name for the captured video file. 9 Click Done to add the captured video file automatically to your movie project. Capturing recorded video from a DV camera For best results when using muvee autoProducer, capture only video footage that you are most interested in using in your movie project. To capture recorded video to your hard disk drive: 1 Connect your DV camera to the FireWire (IEEE 1394) port on your computer. 2 Turn on the camera and set it to VCR mode. Refer to the instructions in the manufacturer's documentation. 3 Click the Import Video/Pictures from a device button. 4 Select From My Camcorder. 5 Click the Play button to start viewing the video. 6 Click Start Capture when you see the start of the video footage that you want to use in your movie project. 7 Click Stop Capture to stop capturing. 8 Repeat steps 5 and 6 to capture additional sections of video footage. 9 Click Capture Folder to specify a folder for the captured video file. 10 Click Filename to specify a file name for the captured video file. 11 Click Done to automatically add the captured video files to your movie project. Adding videos To add video files to your movie project: 1 Click the Add video button in the Video/Pictures area. The Add Video window opens. 2 Browse the folders on your hard disk drive to select existing video files for your movie: Add up to three video files. Select multiple video files by pressing and holding the Ctrl key on your keyboard while you select the files. 3 Adjust the order of the video files by dragging and dropping the files. NOTE: To remove a clip from the project, select it, and then click the trash can icon. Getting Started Updated Information 11