HP m9040n Getting Started Guide - Page 17
Adding pictures, Rotate Image Clockwise, magicSpot, Manual, trash can
![]() |
UPC - 883585318483
View all HP m9040n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Adding pictures To add still-image picture files to your movie project: 1 Click the Add pictures button in the Video/Pictures area. The Add Pictures window opens. 2 Browse the folders on your hard disk drive to select existing still-image files for your movie: Add up to 50 picture files. Select multiple picture files by pressing and holding the Ctrl key on your keyboard while you select the files. Click Open to add pictures to your Video/Pictures area. 3 Adjust the order of the picture files by dragging and dropping them. NOTE: To remove a picture from the project, select it, and then click the trash can icon. 4 Click the Rotate Image Clockwise button to rotate a picture. 5 You can use the magicSpot feature in muvee autoProducer to control the pan and zoom motion that is applied to your picture: a Click the magicSpot button to open the magicSpot window. b Click the Manual button to display two overlapping frames over your picture. c Move the frames around to set the start and end points for motion. The arrow in the frames shows the direction of motion. d When you are done, click OK. Getting Started Updated Information 13
![](/manual_guide/products/hewlettpackard-m9080n-getting-started-guide-a38aeec/17.png)