HP mt42 Maintenance and Service Guide - Page 56
Touchpad button board, antenna from the NFC module
View all HP mt42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Touchpad button board Description Touchpad button board Spare part number 821171-001 Before removing the touchpad button board, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer. 4. Remove the bottom cover (see Bottom cover on page 25). 5. Remove the battery (see Battery on page 28). 6. Remove the following components: a. Keyboard (see Keyboard on page 36) b. Internal base plate (Internal base plate on page 41) Remove the touchpad button board: 1. Disconnect the cable from the touchpad to the smart card reader board (1), and then disconnect the NFC antenna from the NFC module (2). 2. Lift the tape (3), and then remove the 2 Phillips PM2.5x2.5 screws (4) that secure the touchpad button board to the top cover. 3. Lift the top of the touchpad button board up, and then pull it forward to remove it from the slot (5). Reverse this procedure to install the touchpad board. 46 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts