HP vc4825T Troubleshooting Guide: HP vc4820T and vc4825T Thin Clients - Page 34
Changing BIOS Settings Using the F10 Utility, F10=Setup, Save & Exit Setup, Exit without Saving
View all HP vc4825T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Parallel Mode ECP Mode Use DMA USB Controller External USB Ports Halt On Security Option USB Keyboard Support USB Mouse Support ECP/EPP DMA3 Enabled Enabled All, but Keyboard Setup Enabled Disabled Standard, EPP, ECP DMA1 Disabled Disabled No Errors Always Disabled Enabled NOTE: Settings that can be controlled from the operating system with repset can also be controlled remotely by sending the client an Altiris job that uses the repset tool to apply the setting changes. Changing BIOS Settings Using the F10 Utility 1. Turn on or restart the thin client. 2. As soon as the thin client is turned on, press F10 when the "press F10" prompt appears on the screen to enter the Setup Utility. NOTE: If you do not press F10 at the appropriate time, you must restart the thin client and again press F10 when the F10=Setup message displays in the task bar at the bottom of the screen. When the F10 POST Screen display is set to zero seconds, it may be necessary to press and hold F10 on the keyboard, then power on the thin client. 3. The Setup Utility screen is divided into five menu headings and five task actions. The Menu Headings are: System Information, Standard CMOS Features, Advanced BIOS Features, Integrated Peripherals, Power Management Setup The Task Actions are: Load Factory Defaults, Set Administrative Password, Set User Password, Save & Exit Setup, Exit without Saving Use the arrow keys (up and down or left and right) to select the appropriate heading, and then press Enter. To return to the Setup Utility menu, press the Esc key. 4. To apply and save changes, select Save & Exit Setup. If you have made changes that you do not want applied, select Exit without Saving. To reset to original factory settings, select Load Factory Defaults. CAUTION: Do NOT turn the thin client power off while the ROM is saving the Setup (F10) changes, because the CMOS could become corrupted. It is safe to turn off the computer only after exiting the F10 Setup screen. Table 3-1 Setup (F10) Utility Main Menu Heading Table System Information Setup Utility-System Information on page 27 Standard CMOS Features Setup Utility-Standard CMOS Features on page 27 26 Chapter 3 BIOS Settings, (F10) Utility