Hisense DH10019TP1WG Use and Care Guide - Page 10

Timer To set Timer for a 30-minute to 24-hour delay before the dehumidifier is turned off (the dehumidifier must be On): 1.Press TIMER. Timer indicator light will come on, and the display will flash. The display will show remaining time before the dehumidifier will turn off. This feature pumps water horizontally or vertically. Pump water to a drain, out a window or anywhere you think suitable. IMPORTANT: You must connect the drain hose to the unit before pressing the Pump button, or the pump will not operate. See "Pump drain" for connecting instructions. 2. Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours. To set Timer to turn on the dehumidifier, with previous setting: 1. Turn off the dehumidifier. 2. Press TIMER. Timer indicator light will flash. The display will show remaining time before the dehumiditier will turn on. 3. Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours. To clear the Timer delay program: NOTE: Dehumiditier can be either on or off. 1. Press TIMER once after it has been programmed. Display will show remaining time. 2. While the display is showing the remaining time, press TIMER again. Timer indicator light will turn off. To see the remaining time. Press TIMER once after it has been programmed. Display will show remaining time. NOTE: Empty the drain water bucket before setting the timer function. If the water bucket becomes full during the Timer function, the Bucket Full light goes on and dehumidification stops. P 1. Press PUMP to activate the pump system for active drainage. 2. Once the pump button is pressed, the pump light will switch on. NOTE: ■ If the pump light flashes, it means that the pump is not functioning properly. ■ If the drain hose is not correctly connected to the unit or is bent, the pump light will flash and the pump system will not work. See "Trouble shooting" for direction. Site for installing hose for pump function: Water Container Hose length is 16 feet Max. Clean Filter 1. When the Clean Filter indicator light is on, remove, clean and replace the air filter. See "Cleaning the Air Filter". 2. Press the Clean Filter button to reset the filter monitor. Height should be less than 16 feet NOTE: When the light is on, it will remain on for 180 hours or until you press Clean Filter button. Pump (for Pump function model only) 8 Dehumidifier