Hisense DH10019TP1WG Use and Care Guide - Page 7
Power Supply Requirements, It is the customer's responsibility, Recommended Grounding Method
View all Hisense DH10019TP1WG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Specific electrical requirements are listed in the chart below. Follow the requirements for the type of plug on the power supply cord. Power Supply Requirements ■ 115V (103.5 min. to 126.5 max.) ■ 15A time-delay fuse or circuit breaker Recommended Grounding Method This dehumidifier must be grounded. This dehumidifier is equipped with a power supply cord with a three-prong grounding plug. The cord must be plugged into a mating, grounded three-prong outlet, grounded in accordance with all local codes and ordinances. If a mating outlet is not available, it is the customer's responsibility to have a properly grounded three-prong outlet installed by a qualified electrician. It is the customer's responsibility: ■ To contact a qualified electrical installer. ■ To assure that the electrical installation is adequate and conforms to the Nation Electrical Code, ANSI/NFPA 70-last edition, and all local codes and ordinances. Copies of the standards listed may be obtained from: Nation Fire Protection Association 1 Batterymarch Park Quincy, Ma 02169-7471 www.nfpa.org To reduce the risk of injury to persons, malfunction, or damage to the product or property when using this appliance, follow basic safety precautions, including the following: NOTE: Your model may differ from the one shown. A A A. 12" to 18" (30.5cm to 45.7cm) ■ Do not locate outdoors. This dehumidifier is intended for indoor, residential use only. This dehumidifier is not recommended for commercial use. ■ Allow at least 12" to 18" (30.5cm to 45.7cm) of space on the rear and sides of the dehumidifier for models with back louver and above the dehumidifier for models with top louvers. ■ You will need a surface strong enough to support the dehumidifier when its bucket is full of water. ■ You will need a surface level enough to keep the water from spilling when the bucket is full of water. ■ Do not block the louvers of the unit . ■ Never operate this dehumidifier in an area that is likely to accumulate standing water. If this condition develops, for your safety disconnect the power supply before stepping into the water. 5