Hisense DH10019TP1WG Use and Care Guide - Page 8

DEHUMIDIFIER USE Setting the Controls Control Panel Control Type1 AUTO DRY CONTINUOUS MANUAL SET HIGH MID EMPTY BUCKEY LOW TIMER MODE POWER CLEAN FILTER FAN PUMP Control Type2 and immediately restarted, to protect the compressor there is a 3-minute delay until the compressor restarts. ■ When the dehumidifier is operating, the indoor temperature will rise. The dehumidifier does not have a cooling /heating function. Heat is generated during operation, so the room temperature may be increased by about 6ºF(3ºC) depending on the usage conditions (indoor temperature, size of the room). AUTO DRY SUPER DRY MANUAL SET HIGH MED EMPTY BUCKET LOW QUIET TIMER MODE POWER CLEAN FILTER FAN PUMP NOTE: ■ The control panel of your model may differ from the one shown above. ■ Pump button may not be displayed on the panel if your model does not have these functions. Starting/Stopping the Dehumidifier The dehumidifier should be upright for at least 2 hours before use. NOTE: ■ Before turning on the dehumidifier, be sure that the bucket is empty and fits all the way into the dehumidifier. ■ Each time you unplug the dehumidifier or power is interrupted, the controls will return to the previous settings when power is restored. ■ Humidity displayed is between 30% Relative Humidity and 90% Relative Humidity. ■ Humidity can be set between 30% Relative Humidity and 80% Relative Humidity. ■ It's important to set the desired humidity level to an achievable setting. To ensure energyefficient operation, only use the dehumidifier in a closed space, with no open windows or other sources of moist air (to avoid continuous running). ■ Operating temperature is between 38ºF to 90ºF (3.2ºC to 32.2ºC). At temperatures of 38ºF(3.2ºC)or less, water freezes inside the product. At temperatures over 90ºF(32.2ºC),the internal temperature of the product trips a protective device which deactivates the product to avoid product damage. ■ The compressor has a 3-minute delay before restarting. If the product is stopped 1. Plug into a grounded three-prong outlet. 2. Press POWER to turn on the dehumidifier. 3. Press FAN to choose the fan speed. 4. Press MODE to choose the mode. 5. Press the plus or minus button to set the level of humidity. 6. Press POWER to turn off the dehumidifier. NOTE: The dehumidifier will retain your last settings. Empty Bucket Light If this light is on, the fan and the compressor will stop running.This light indicates that you need to check: ■ If the bucket is full, empty and re-install bucket. ■ If the bucket is not in position, remove the bucket and re-install it. Make sure the bucket fits all the way into the dehumidifier and the bucket light is off, or duhumidifier will not run. 6