Hitachi 7K400 Specifications - Page 115
Read Continuous bit, Write Continuous bit, Handle Streaming Error bit, Streaming Logs
![]() |
UPC - 000053412935
View all Hitachi 7K400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
10.18.5 Read Continuous bit If the Read Continuous bit is set to one for the command, the device shall transfer the requested amount of data to the host within the Command Completion Time Limit even if an error occurs. The data sent to the host by the device in an error condition is vendor specific. 10.18.6 Write Continuous bit If the Write Continuous bit is set to one for the command, and an error is encountered, the device shall complete the request without posting an error. If an error cannot be resolved within the Command Completion Time Limit, the erroneous section on the media may be unchanged or may contain undefined data. A future read of this area may not report an error, even though the data is erroneous. 10.18.7 Handle Streaming Error bit The Handle Streaming Error bit specifies to the device that this command starts at the LBA of a recently reported error section, so the device may attempt to continue its corresponding error recovery sequence where it left off earlier. This mechanism allows the host to schedule error recovery and defect management for content critical data. 10.18.8 Streaming Logs The Streaming Data Transfer feature set requires two error logs and one performance log. These logs are accessed via the Read Log Ext command, The information included in the error logs is volatile and is not maintained across power cycles, hard resets, or sleep. These error logs are 512 bytes in length and retain the last 31 errors that occurred during any Streaming Data transfer. Deskstar 7K400 Hard Disk Drive Specification 101
![](/manual_guide/products/hitachi-7k400-specifications-548f643/115.png)