Hitachi GD8000 User Guide - Page 45
The Security Menu, Field, Setting, Description, The Exit Menu
View all Hitachi GD8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
GD8000 User Guide The Security Menu Customizing Your BIOS Field Change Supervisor Password Setting Enter New Password Change User Password Enter New Password Description Install or Change the Supervisor password. This field must be set before a user level password can be set. You will be prompted to set and then verify a new password. Type in six or fewer keystrokes. If you make an error, press Esc to start over. Install or Change the User password. Clear User Password Password Check Clear User Password? OK Cancel Setup Always Immediately clears the User password. This option is only available when a user password has been set. This option is only available when a password has been set. Setup: requires a password when entering the setup utility. Always: requires a password during boot and when entering the setup utility. CAUTION Incorrect settings can cause your system to malfunction. To correct mistakes, return to Setup and restore the Setup Defaults by pressing F9. The Exit Menu You use the exit menu to leave the BIOS Setup Utility. Field Save Changes and Exit Setting Ok Cancel Discard Changes and Exit Discard Changes Ok Cancel Ok Cancel Load Optimal Defaults Ok Cancel General Dynamics Itronix | 72-0137-003 Description Exit system setup after saving the changes. The F10 key can be used for this operation. Exit system setup without saving any changes. The Esc key can be used for this operation. Discards changes done so far to any of the setup questions. The F7 key can be used for this operation. Load Optimal Default values for all the setup questions. The F9 key can be used for this operation.