Hitachi NT65MA2 Instruction Manual - Page 12
Lubrication
UPC - 717709007727
View all Hitachi NT65MA2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
English 3. Air hose Air hose must have a minimum working pressure rating of 150 psi (10.4 bar 10.6 kgf/ cm2) or 150% of the maximum pressure produced in the system, whichever is higher. 4. Hose couping ⅜ The Nailer can be installed as follows: Remove the dust cap placed at the air inlet. Dust Cap Install a 3/8 NPT male plug at the air inlet. ⅜ A female coupler must be on the air hose. The hose coupling (male plug-female coupler) must remove all pressure from the Nailer when disconnected. Never use a non reiieving coupler on the Nailer. 3/8 NPT Male Plug 5. Air consumption Using the Air consumption table and the Air compressor size formula, find a correct compressor size. Air consumption table psi Operating pressure (bar) (kgf/cm2) 80 (5.5) (5.6) 90 (6.2) (6.3) 100 (6.9) (7) Air consumption ft3/cycle (ltr/cycle) .034 .038 .042 (.95) (1.08) (1.20) Air compressor size formula Amount of air required = number of Nailers × average nails driven each minute per Nailer × air consumption at given air pressure × safety factor (always 1.2) Example: 3 Nailers operating at 100 psi driving 30 nails per minute Amount of air required = 3 × 30 × .042 (1.20) × 1.2 = 4.5 CFM (ft3/min) (95 ltr/min) After making the calculations as shown above, you should find a compressor providing 4.5 CFM of air that is required. LUBRICATION It is important that the Nailer be properly lubricated. Without proper lubrication, the Nailer will not work properly and parts will wear prematurely. ⅜ Use Hitachi pneumatic tool lubricant. Do not use detergent oil or additives. These lubricants will harm the O-rings and other rubber parts. This will cause the Nailer to malfunction. ⅜ Filter-regulator-lubricator units should always be used. Keep the lubricator filled with Hitachi pneumatic tool lubricant. ⅜ If a lubricator is not available, supply 5 - 10 drops of Hitachi pneumatic tool lubricant into the air plug on the Nailer twice a day. 12