Hitachi NT65MA2 Instruction Manual - Page 22
Using The Blow Nozzle - case
UPC - 717709007727
View all Hitachi NT65MA2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
English If nails are driven too shallow, turn the adjuster to the deep side. 3 Stop turning the adjuster when a suitable position is reached for a nailing test. 4 Connect the air hose. ALWAYS WEAR SAFETY GLASSES. Perform a nailing test. 5 DISCONNECT AIR HOSE FROM NAILER. 6 Choose a suitable position for the adjuster. 2 Too Deep 2 Too Shallow Turn Adjuster Flush Turn Adjuster Flush USING THE BLOW NOZZLE WARNING ● Be sure to release your finger from the trigger before using the blow nozzle. ● Do not point the air outlet at a person. ● Do not use the blow nozzle with the push lever left fit. This Nailer has a blow nozzle that blows out wood shavings which occur during work. Press the knob with your thumb to use the blow nozzle, as shown in the figure. Knob NOTE: ● When the blow nozzle is used for a long time, the nailing force may degrade temporarily. In this case, allows the air supply pressure to stabilize before starting work. ● Oil in the body or drained water from the compressor can sometimes spout out of the air outlet. It is recommended that you once conduct a test before use and see if such phenomenon happens at an environment where spouted oil will cause any inconvenience. air outlet 22