Hitachi NT65MA2 Instruction Manual - Page 16
Adjusting Air Pressure, Loading Nails
UPC - 717709007727
View all Hitachi NT65MA2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
English ADJUSTING AIR PRESSURE WARNING ● Do not exceed 120 psi (8.3 bar 8.5 kgf/cm2). Adjust the air pressure at recommended operating pressure 70 - 120 psi (4.9 - 8.3 bar 5 - 8.5 kgf/cm2) according to the length of nails and the hardness of workpiece. The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a higher than required air pressure unnecessarily over stresses the Nailer. LOADING NAILS WARNING ● When loading nails into the nailer, be sure to remove your finger from the trigger and disconnect the air hose from the nailer. (1) Insert nail strip into rear of magazine. Magazine (2) Slide the nail strip forward in the magazine. The nail strip should pass the nail stopper. Nail Stopper 16
English
16
Magazine
WARNING
WARNING
Nail Stopper
ADJUSTING AIR PRESSURE
●
Do not exceed 120 psi
(8.3 bar
8.5 kgf/cm
2
).
Adjust the air pressure at recommended operating pressure 70 – 120 psi (4.9 – 8.3 bar
5 –
8.5 kgf/cm
2
) according to the length of nails and the hardness of workpiece.
The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a
higher than required air pressure unnecessarily over stresses the Nailer.
LOADING NAILS
●
When loading nails into the nailer, be sure to remove your finger
from the trigger and disconnect the air hose from the nailer.
(1)
Insert nail strip into rear of magazine.
(2)
Slide the nail strip forward in the magazine.
The nail strip should pass the nail stopper.