Hitachi NV65AH Instruction Manual - Page 11

(2) Adjust the air pressure to 70 psi (4.9 bar 5 kgf/cm2). Connect the air hose. Do not load any nails in the Nailer. Ⅺ THE NAILER MUST NOT LEAK AIR. Hold the Nailer downward and pull the trigger. Ⅺ THE NAILER MUST NOT OPERATE. English ADJUSTING AIR PRESSURE WARNING Pull Trigger (3) With finger off the trigger, depress the push lever against the workpiece. Ⅺ THE NAILER MUST NOT OPERATE. ⅷ Do not exceed 120 psi (8.3 bar 8.5 kgf/cm2). Adjust the air pressure at recommended operating pressure 70 - 120 psi (4.9 - 8.3 bar 5 - 8.5 kgf/cm2) according to the length of nails and the hardness of workpiece. The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a higher than required air pressure unnecessarily over stresses the Nailer. LOADING NAILS WARNING ⅷ When loading nails into Nailer, 1) do not pull trigger; 2) do not depress push lever; and 3) keep Nailer pointed downward. (1) Press the magazine stopper and open the magazine cover. Magazine Cover Do not pull Trigger Depress Push Lever (4) Without touching the trigger, depress the push lever against the workpiece. Pull the trigger. Ⅺ THE NAILER MUST OPERATE. (5) With the Nailer off the workpiece, pull the trigger. Depress the push lever against the workpiece. Ⅺ THE NAILER MUST OPERATE. (6) If no abnormal operation is observed, you may load nails in the Nailer. Drive nails into the workpiece that is the same type to be used in the actual application. Ⅺ THE NAILER MUST OPERATE PROPERLY. Magazine Stopper Nail Holder (2) Adjust the position of the nail holder according to the nail length. The nail will not feed smoothly if the nail holder is not correctly adjusted. 1 Turn the nail holder about 90 degrees counterclockwise. 2 Move the nail holder up and down to align the top of the nail holder with a mark on the holder shaft in accordance with the length of the nails being used. 3 Turn the nail holder 90 degrees clockwise until you hear "click". Nail Holder Holder Shaft 2 3 1 - 11 -