Hitachi NV65AH Instruction Manual - Page 12
Nailer Operation, Danger, Warning - siding coil nailer
UPC - 717709004689
View all Hitachi NV65AH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
English Top of the Nail Holder Holder Shaft 1-1/2" (38mm) 1-3/4" and 2" (45,50mm) 2-1/4", 2-3/8" and 2-1/2" (57,60,64mm) Nail Holder First Nail Driving Hole Guide Slot 3 2 1 4 Nail guide NOTE: Before loading nails in the magazine, adjust the nail holder. If the magazine cover is forcibly closed without adjusting the nail holder correctly, the nail holder may be damaged. (3) Place the nail coil in the magazine. Insert the first nail into the magazine opening. Magazine Opening First Nail Magazine Nail (4) Close the magazine cover. (5) Grip the nail guide and knob with finger. Press the knob down and swing the nail guide open. Magazine Opening Pawl Feeder 2 Guide Surface NOTE: Be careful not to deform the collated wires and not to disengage the nails with the guide surface. Otherwise, the nail guide will not close correctly. 4 Pulling the nails to the right, swing the nail guide closed. (7) Lock the knob completely. NAILER OPERATION Read section titled "SAFETY"(pages 4 - 6). DANGER ⅷ Operators and others in work area MUST wear safety glasses with side shields which conforms to ANSI Z87.1 specifications. WARNING Knob Nail Guide ⅷ NEVER point tool at yourself or others in work area. ⅷ Keep fingers AWAY from trigger when not driving nails to avoid accidental firing. ⅷ Choice of triggering method is important. Please read and understand "METHODS OF First Nail OPERATION" found below. ⅷ Never place your hands or feet closer than 8 (6) 1 Uncoil enough nails to reach the driving hole. inches (200 mm) from firing head when using. 2 Insert the first nail into the driving hole and the ⅷ Do not drive nails on top of other nails or with second nail between the two pawls of the feeder. Nailer at too steep of an angle; nails can ricochet 3 Fit the nail heads in the guide slot. and hurt someone. ⅷ In order to avoid double fire or unwanted ejection of a nail due to bouncing of the Nailer. 1) do not push Nailer on workpiece with strong force; 2) take Nailer away from workpiece using recoil; 3) release trigger quickly when performing trigger fire. - 12 -