Hitachi NV65AH Instruction Manual - Page 15

English MAINTENANCE NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer. Some illustrations in this Manual may show details or attachments that differ from those on your own Nailer. MAINTENANCE AND INSPECTION Read section titled "SAFETY" (pages 4 - 6). WARNING ⅷ Disconnect air hose and remove all nails from Nailer when: 1) doing maintenance and inspection; and 2) clearing a jam. 1. Clearing a jam Remove a jammed nail in the following order: 1 DISCONNECT AIR HOSE. 2 Open the nail guide. 3 Insert a rod into the outlet. Tap the rod with a hammer. Hammer rod 2. Inspecting the push lever 1 DISCONNECT AIR HOSE. 2 Clean the push lever sliding part. Lubricate it with Hitachi pneumatic tool lubricant. Nose Push Lever 1 Disconnect air hose Lubricate 3. Inspecting the feeders 1 DISCONNECT AIR HOSE. 2 Clean the knob sliding part. Lubricate it with Hitachi pneumatic tool lubricant. outlet 1 Disconnect air hose 4 Remove the jammed nail with a slotted screw driver. Nail Slotted Screw Driver 5 Cut the deformed collated wire with nippers. Correct the deformation. 6 In case of frequent jam, contact a Hitachi authorized service center. Knob 1 Disconnect air hose Nail Guide 3 Open the nail guide and remove dust. Lubricate the sliding groove of the feeder and shafts. CAUTION ⅷ Check that nail stopper (A) and nail stopper (B) slide smoothly by pusing them with finger. If not smooth, nails can be driven at an irregular angle and hurt someone. - 15 -