Hoover F5835900 Owners Manual - Page 12

5.Before connecting tube (G) to cleaner, make sure black tabs are extended by pulling tan collar toward tube. Open door on hood labeled "Stair/ upholstery Cleaning Connection". Press round solution tube connector onto round projection inside door. Press connector collar down firmly to ensure that it is fully connected. 6. The tank replaces in a hinge-like manner. Position front of lid under tabs (H) on front of tank. Rotate lid down onto tank. Make sure lid is secure on all sides before cleaning. For full suction, it is important that the recovery tank lid is properly secured before cleaning. Reverse procedure to remove hose and solution tube. Raise deep cleaner handle to upright position. How to attach tool All tools connect to the hose in the same manner. 1. Attach tool to connector end of hose by sliding it onto connector until the tab (I) locks it securely. Using your thumb, push forward and up on the latch (J) to remove tool as shown. Before using tool It may be necessary to remove air from the system ("prime the pump") so the clean solution will flow to the tool. Follow these steps: 1. Attach tool to hose and turn the deep cleaner ON. 2. Put the tool on a hard surface or against your hand to block off the suction. 3. Wait a few seconds (can take up to 15 seconds). Then squeeze the trigger and begin cleaning. Follow the instructions on pages 13 and 14 for the appropriate cleaning task. After using tool 1. Follow steps a and b for "After cleaning" on page 9. 2. Rinse tool and hose by filling sink with a small amount of water. Turn deep cleaner ON and pick up the water with the tool. 3. Drain hose by turning deep cleaner ON and holding end of hose up for several seconds. Do not press trigger. 4. Disconnect deep cleaner from electrical outlet. 5. Drain solution tube by placing round end in sink and raising nozzle above your head. Press the trigger. 6. Proceed with steps c, d and e for "After cleaning" on page 9. 12