Hoover F5835900 Owners Manual - Page 8
Recovery, empty - parts for
View all Hoover F5835900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
kzS_] B C Pour detergent into tank. Fill tank to fill line (B) (1 gallon) with hot tap water. To assure proper performance, use only HOOVER cleaning detergent. If rubber ring (C) on cap has become dislodged, repesitien it with uneven side against ledge (D) as shown. Replace cap. Rotate cap clockwise until it locks in place. Cap must be locked in place for proper performance and to prevent leaking. Position bottom of tank into unit and press on tank handle to snap tank into place. Recovery tank (lower tank) The recovery tank holds the dirty solution that is picked up from the carpet. When the recovery tank is full, the automatic shut-off will engage (see page 7) and the tank must be emptied. How to empty Turn deep cleaner off and disconnect from electrical outlet. To prevent possible leaking, remove clean solution tank (Fig. 2-6) by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture). Step on handle release pedal and lower handle until it rests on the floor. If cleaning stairs or upholstery, remove hose by reversing procedure as shown on pages 11 and 12. Rotate recovery tank latches (E) outward (one on each side of tank). Lift tank off of deep cleaner and carry it to a sink or drain. Unlatch back part of tank lid and remove lid. Empty tank. Pour dirty water out from the rear of the tank (F). The lid replaces in a hinge-like manner. Position the front of lid under tabs (G) on front of tank. Rotate lid down onto tank. Make sure that the lid is secure on all sides before placing tank on cleaner. For full suction, it is important that the recovery tank lid is properly secured before cleaning. Replace tank and press down to ensure that it is properly seated in place. Rotate latches (E) (one on each side of tank) inward to lock tank in place, To continue cleaning stairs or upholstery, replace hose as shown on pages 11 and 12. Raise handle to upright position and replace upper clean solution tank.