Hoover F5835900 Owners Manual - Page 4

Attach, upper, handle, holder - model

Get Hoover F5835900 PDF manuals and user guides View all Hoover F5835900 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

The assembled cleaner will look like this drawing. A Attach upper handle Remove clean solution tank (upper tank) from deep cleaner. I!_-.1 B With cord hook (A) to back of deep cleaner, push upper handle down onto lower handle. Push bolts into holes on front of han- dle. If bolts will not go through hole easily handle is not pushed completely down. C Attach hose holder Position hose holder (B) onto handle by matching tabs on rack with openings on back of handle. Make sure bolts are through holes. Place nuts in recessed areas on back of hose holder. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screwdriver. Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience. When handle sections are completely together, squeeze trigger (C) on upper handle to snap trigger rod in place. Attach tool holder Remove tool and taped screw from holder. Insert projections on holder into slots on back of cleaner. 4 Slide holder down into place. Insert screw at (D) and tighten with a Phillips screwdriver. Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
The assembled
cleaner will look like this
drawing.
Attach
upper
handle
Remove
clean
solution tank (upper
tank)
from deep cleaner.
A
With cord hook (A) to back of deep cleaner,
push upper handle down onto lower han-
dle. Push
bolts
into holes on front
of
han-
dle. If bolts will not go through hole easi-
ly handle is not pushed completely
down.
I!_-.1
B
Attach
hose
holder
Position
hose holder (B) onto handle
by
matching
tabs
on rack with openings
on
back
of handle. Make sure bolts are
through
holes.
Place
nuts
in recessed
areas on
back
of hose holder.
Hold each nut in place
while tightening
each bolt securely
(from the front of the handle)
with a
Phillips screwdriver.
Only two nuts are needed
on this
model.
The extra nut is not required
but
has been provided
for your conve-
nience.
C
When
handle sections
are completely
together,
squeeze
trigger
(C) on upper
handle to snap trigger
rod in place.
Attach
tool
holder
Remove tool and taped
screw from
holder. Insert
projections
on holder
into
slots on back
of cleaner.
4
Slide holder down
into place. Insert
screw
at (D) and tighten
with a Phillips
screwdriver.
Replace
clean
solution tank (upper
tank) by positioning
bottom first.
Press
on tank handle
to snap top of tank into
place.