Husqvarna AUTOMOWER 450XH Owner Manual - Page 35
Operating mode - Park, 5 To stop the product, 6 To switch off the product, 7 To charge the battery
View all Husqvarna AUTOMOWER 450XH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
If the product charges in the Secondary area mode, it will fully charge, move out about 50 cm / 20 in. and then stop. This means that the product is charged and prepared to start to cut. Note: It is recommended to change the operation selection to Main area before you put the product in the charging station. 4.3.4 Spot cutting Spot cutting means that the product mows in a spiral pattern in order to cut the grass in the area where it was started. You can select how the product must continue to operate when cutting is complete. • Use the right arrow button to select Main Area or Secondary Area. 4.4 Operating mode - Park When selecting Park the following operation selections can be selected: • Park until further notice • Start again in 3 hours • Start with next timer 4.4.1 Park until further notice The product stays in the charging station until another operating mode is selected by pressing the START button. 4.4.2 Start again in 3 hours The product stays in the charging station for 3 hours and then automatically goes back to the usual operation. This operation selection is applicable when it is necessary to pause operation. 4.4.3 Start with next timer The product stays in the charging station and starts to operate on the next Timer setting. 4.5 To stop the product 1. Press the STOP button on top of the product. The product stops and the blade motor stops. 4.6 To switch off the product 1. Press the STOP button on top of the product. 2. Set the Main switch to position 0. WARNING: Always switch off the product using the main switch if it requires maintenance, or if the product must be moved outside the work area. 4.7 To charge the battery When the product is new or has been stored for a long period, the battery can be empty and needs to be charged before starting. In the Main area mode, the product automatically alternates between mowing and charging. WARNING: Only charge the product using a charging station and a power supply which is intended for it. Incorrect use may result in electric shock, overheating or leakage of corrosive liquid from the battery. In the event of leakage of electrolyte flush with water and seek medical help if it comes in contact with the eyes etc. 1. Set the Main switch to position 1. 2. Place the product in the charging station. 3. Open the hatch and slide the product in as far as possible to ensure proper contact between the product and the charging station. 1230 - 001 - Operation - 35