IBM 39M5657 User Guide - Page 24
Mount, Drive, Server/Enclosure
View all IBM 39M5657 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
A67E0049 Attention SCSI termination must be provided externally to the drive. Mount the Drive into the Server/Enclosure To mount the drive into a enclosure: __ 1. Remove the cover of your enclosure (refer to the instructions in the documentation provided with your enclosure). __ 2. Place the drive into the enclosure so that the tape load compartment of the drive faces the tape load compartment of the enclosure. __ 3. Insert two M3 screws into the mounting holes 2 of the two side brackets located on the left and right sides of the chassis. Attention When inserted into the drive, the length of the mounting screws must not exceed 3.5 mm (0.14 in.) inside the chassis. If the length exceeds this measurement, the drive may become damaged. 1 2 < 3.5 mm (0.14 in.) Figure 6. Mounting holes on drive. The holes are located on both sides of the drive. The drive is shown with a front bezel. 8 IBM 400/800GB LTO3 Tape Drive User's Guide a82ru004