IBM HS20 User Guide - Page 34
Removing, blade, server, BladeCenter - 8677
![]() |
UPC - 087944983033
View all IBM HS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
v Do not touch solder joints, pins, or exposed printed circuitry. v Do not leave the device where others can handle and possibly damage it. v While the device is still in its static-protective package, touch it to an unpainted metal part of the BladeCenter unit or any unpainted metal surface on any other grounded rack component in the rack you are installing the device in for at least 2 seconds. This drains static electricity from the package and from your body. v Remove the device from its package and install it directly into the blade server without setting it down. If it is necessary to set the device down, place it back into its static-protective package. Do not place the device on your blade server cover or on a metal surface. v Take additional care when handling devices during cold weather. Heating reduces indoor humidity and increases static electricity. Removing the blade server from the BladeCenter unit The following illustration shows how to remove the blade server from the BladeCenter unit. Notes: 1. The illustrations in this document might differ slightly from your hardware. 2. Unless otherwise stated, references to the BladeCenter unit also apply to the BladeCenter T unit. Type 8677 20 BladeCenter HS20 Type 8832: Installation and User's Guide
![](/manual_guide/products/ibm-hs20-user-guide-e2f550c/34.png)