IBM x3755 Installation Guide - Page 29
Installing the Remote Supervisor Adapter II SlimLine
View all IBM x3755 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Installing the Remote Supervisor Adapter II SlimLine An optional IBM Remote Supervisor Adapter II SlimLine can be installed only in its dedicated connector on the I/O board. Note: If a Remote Supervisor Adapter II SlimLine is installed in the server, when you turn on the server for the first time, the server might appear to be unresponsive for an unusual length of time (one minute to several minutes). This is normal operation while the Remote Supervisor Adapter II SlimLine gathers information about the server. To install a Remote Supervisor Adapter II SlimLine, complete the following steps: 1. Read the safety information that begins on page v and "Installation guidelines" on page 7. 2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables necessary to install the device. Attention: When you handle static-sensitive devices, take precautions to avoid damage from static electricity. For details about handling these devices, see "Handling static-sensitive devices" on page 9. 3. Remove the top cover. Remote Supervisor Adapter II SlimLine Remote Supervisor Adapter II SlimLine guide Retention latch 4. Carefully grasp the Remote Supervisor Adapter II SlimLine assembly by its top edge or upper corners, and align it with the guide and the connector on the I/O board. Attention: Incomplete insertion might cause damage to the I/O board or the adapter. 5. Press the assembly firmly into the connector and under the retention latch on the guide. If you have other devices to install or remove, do so now; otherwise, go to "Completing the installation" on page 20. Chapter 2. Installing options 17