Icom IC-F8101 Instruction Manual - Page 24
SELCALL/ALE OPERATION, ■ Selcall/ALE, Selcall or ALE - service manual
View all Icom IC-F8101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
4 SELCALL/ALE OPERATION ■■Selcall or ALE Selcall uses a 4 or 6-digit ID address and allows you to make individual or group calls. The ALE (automatic link establishment) is a system which automatically selects an available frequency and establishes a communication link. The IC-F8101 ALE system compiles with basic requirements of FED-STD-1045A. DDAvailable calls • Selective call Selective call allows you to make individual or group calls using an individual ID (identification) assigned to each transceiver. • Phone call Allows you to make a Phone call through a telephone interconnect service provider. • Message call Allows you to exchange text messages of up to 64 characters* with the intended ID station. * Icom Selcall: 6 4 characters (upper case/Lower case letters) Open Selcall: 3 2 characters (Only upper case let- ter) • Send Position call Allows you to send your own position information to the intended ID station. • Get Position call The Get Position call allows you to request the intended ID station to send its position information. • Get Status call (Only Icom Selcall) Requests to send radio status information including power supply voltage, signal strength, output power, VSWR, and so on. • Stun call (Only Open Selcall) The Stun call disables the specified station from either transmitting and receiving. • RFDS emergency call (Only Australian versions) The RFDS (Royal Flying Doctor Service) emergency call uses a 2-Tone signal for an emergency call. • Emergency call Allows you to send an emergency signal with your own position information. • The Icom Selcall uses Icom original commands, and may not be compatible with other brands. • Depending on the preprogramming, you can select the Open Selcall*. * The Open Selcall is compatible with other transceiver brands. Ask your dealer for details. • Channel Test call The Channel Test call allows the user to determine the signal quality between their transceiver and a specific transceiver, before making individual or group calls. • ALE individual or net call Automatically establishes a communication link by using the ALE table. • ALE sounding Automatically sends a sounding signal at a selectable interval (0.5-11 hours) to check the propagation, and stores the data in a table. Manual soundings can also be sent. • ALE AMD (Automatic Message Display) Automatically sends and receives text messages of up to 90 characters. 18