Icom ID-31A Instruction Manual - Page 32
■ Setting a tuning step, ■ Setting a frequency, Tuning step selection
View all Icom ID-31A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
5 BASIC OPERATION ■■Setting a tuning step The following tuning steps are selectable. • 5.0 kHz • 6.25 kHz • 10.0 kHz • 15.0 kHz • 20.0 kHz • 25.0 kHz • 50.0 kHz • 100.0 kHz • 125.0 kHz • 12.5 kHz • 30.0 kHz • 200.0 kHz D Tuning step selection q Push [V/MHz] to select VFO mode, if necessary. w P ush to open the Quick Menu screen. e P ush D-pad(E) to select "TS," and then push D-pad(Ent). D-pad (Ent) (�) r R otate [DIAL] to select the desired tuning step. t P ush D-pad(Ent) to save the setting and exit the Quick Menu screen.
23
5
BASIC OPERATION
■
Setting a tuning step
The following tuning steps are selectable.
• 5.0 kHz
• 6.25 kHz
• 10.0 kHz
• 12.5 kHz
• 15.0 kHz
• 20.0 kHz
• 25.0 kHz
• 30.0 kHz
• 50.0 kHz
• 100.0 kHz
• 125.0 kHz
• 200.0 kHz
D
Tuning step selection
q
Push [V/MHz]
to select VFO mode, if necessary.
w
Push
to open the Quick Menu screen.
e
Push
D-pad(
E
)
to select “TS,” and
then push
D-pad(Ent)
.
D-pad
(
�
)
(Ent)
r
Rotate
[DIAL] to select the desired
tuning step.
t
Push
D-pad(Ent)
to save the setting
and exit the Quick Menu screen.
■
Setting a frequency
q
Push [V/MHz]
to select VFO mode, if necessary.
w
Rotate [DIAL] to select the desired frequency.
• The frequency changes according to the selected tuning steps.
See the previous content to set the tuning step.
• When VFO mode is selected, push [V/MHz]
then rotate
[DIAL] to change the frequency in 1 MHz steps. Or push [V/MHz]
again for 10 MHz* steps. (
* Depending on versions, 10 MHz
tuning step is selectable.
) Push [V/MHz]
again to cancel it.
25 kHz tuning step
[DIAL]
The frequency changes accord-
ing to the selected tuning step.
After pushing [V/MHz] in the
VFO mode, [DIAL] changes the
frequency in 1 MHz or 10 MHz
steps.
[DIAL]