Icom ID-31A Instruction Manual - Page 37

BASIC OPERATION 5 ■ Memory channel programming The Memory mode is very useful to quickly select often-used operating settings. [Example]: Programming 433.600 MHz/FM mode into memory channel 11 (a blank channel). q Push [V/MHz] VFO mode. to select the w S et a desired frequency and operat- ing mode: ➥ Rotate [DIAL] to set a desired fre- quency. ➥ Push [FM/DV] one or more times to select a desired operat- ing mode. ➥ Set other data (e.g. duplex di- rection, frequency offset, tone squelch, etc.), if desired. e Hold down [S.MW] for 1 sec- ond to enter the Select Memory write mode. • 1 short and 1 long beep sound. • The memory channel number blinks. Blinks Select Memory write mode 1 r R otate [DIAL] to select a desired 2 channel. 3 • Call channels (C0, C1), VFO and scan edge channels (00A/00B to 24A/24B), 4 as well as regular memory channels, 5 can be programmed in this way. t H old down [S.MW] for 1 second 6 to program. 7 • 3 beeps sound. • Before returning to the VFO mode, the 8 programmed memory contents are dis- Memory contents played for a moment. is displayed for 9 • Memory channel number automati- a moment 10 cally increases when continuing to hold down [S.MW] for 1 second after 11 programming. 12 13 After programming is finished, return 14 to the VFO mode 15 16 NOTE: Push [CLR] to cancel the program and exit the Select Memory write mode before memory program- 17 ming is finished. 18 19 28