Insignia NS-BK2TBK8 User Guide - Page 23

Dual Beer Kegerator/Beverage Cooler Problem Abnormal beer taste and/or smell. Possible cause Possible solution System requires cleaning. See "Maintaining your kegerator" on page 19. System contamination. Check hoses for possible air leaks. The beer has exceeded its shelf Replace the beer keg with a fresh one. life. Cooler Caution Do not try to repair your kegerator yourself. Doing so invalidates the warranty. You can solve many common beer dispenser problems easily, saving yourself the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service center. Problem Possible cause Possible solution The kegerator does not operate. The cooler door does not close completely. The cooler is not cold enough. The kegerator is unplugged. Make sure that the kegerator is plugged in and that the plug is pushed completely into the outlet. The fuse on the circuit is blown Check the house fuse/circuit breaker box and replace the fuse or or the circuit breaker is reset the circuit breaker. tripped. Power failure. If a power failure occurs, the kegerator turns off. Wait until the power is restored, then turn it on again. The door was not properly Make sure that the door was properly installed. installed. The shelf is out of position. Adjust the shelf properly. The door gaskets are dirty. Clean the door gaskets. The cooler is not level. Level the cooler with the leveling feet. The door has been opened too Make sure that the door is closed properly. often or was not closed properly. You have just added a large Allow time for the new beverage to cool, then check again. amount of warm beverage to the cooler. The temperature control is set Set the control to a colder setting. too warm. www.insigniaproducts.com 23