Insignia NS-FTV27 User Manual (English) - Page 10

NS-FTV27 27-inch Flat Stereo Color TV Note If you press EXIT in the process of AUTO SETUP, the STARTING SETUP stops and changes to the television screen. Note It may take a few seconds for a digital channel picture to appear on screen after being selected. • When you make a menu selection, your changes occur immediately. You do not have to press EXIT to see your changes. • When you are finished programming the menus, press EXIT. Using the menu Cable chart The following chart is typical of many cable system channel allocations. The number on the top is the number on the television. The number or letter on the bottom is the corresponding cable channel. To access the menu using the TV buttons: Press both of the volume and buttons at the same time. The menu screen appears To access the menu using the remote control: Press MENU. The menu screen appears. To select a setting using the TV buttons: Use the channel and buttons and volume and buttons. To select a setting using the remote control: Use the channel and buttons and volume and buttons. Setting the language You can choose from three different languages (English, French, and Spanish) for the on-screen displays. To select a menu language: 1 Press MENU. The menu screen appears. Note If no buttons are pressed for more than 15 seconds, the menu screen returns to normal television operation automatically. Automatic memory tuning To automatically memorize channels: 1 Press MENU. The menu screen appears. 2 Press or to select the SETUP menu, then press or to select AUTO CH MEMORY. 3 Press or . The television begins memorizing all of the channels available in your area. Depending on the reception condition, it may take approximately ten minutes to complete memorizing digital cable channels. Note Some new channels may be added. You should complete the AUTO CH MEMORY procedure periodically. Adding and deleting channels 2 Press or to select SETUP menu. 3 Press or to select LANGUAGE. 4 Press or to select the desired language: English (ENGLISH), French (FRANÇAIS), or Spanish (ESPAÑOL). 5 Press EXIT to return to the normal screen. Memorizing channels This television is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the television's memory. This television can receive up to 250 VHF/UHF channels and 500 cable television channels. To use this television with an antenna, set the TV/CABLE menu option to the TV mode. When shipped from the factory, this menu option is in the CABLE mode. Selecting TV or cable To select TV or cable input: 1 Press MENU. The menu screen appears. 2 Press or to select the SETUP menu. 3 Press or to select TV/CABLE. 4 Press or to select TV or CABLE. • TV-VHF/UHF channels • CABLE-Cable television channels 5 Press EXIT to return to the normal screen. To add or delete channels: 1 Press MENU. The menu screen appears. 2 Press or to select the SETUP menu, then press or to select ADD/DELETE. 3 Press or . The ADD/DELETE menu appears. 4 Press or to select ADD/DELETE, then press . 5 Select the desired channel to be memorized or deleted using or . 6 Press or to select ADD or DELETE. 7 Repeat step 5-6 for other channels you want to add or delete, then press ENTER. 8 Press EXIT to return to the normal screen. Note To return from the ADD/DELETE menu to the SETUP menu, select SETUP MENU, then press or . To add digital channels: 1 Select the digital channel you want to add using the direct channel selection (number) buttons. 2 Press MENU. The menu screen appears. 3 Press or to select the SETUP menu, then press or to select ADD/DELETE. 4 Press or . The ADD/DELETE menu appears. www.insignia-products.com 9