Insignia NS-TDRG75W1 User Guide - Page 22

INSTALLATION INSTRUCTIONS Before you start Before you start installing your dryer, make sure that: • The location you selected has a grounded electrical outlet. See Grounding requirements on page 20. • For U.S. models, you have the correct type power cord (not included). See Electric requirements on page 17. Note: For Canadian models, the power cord comes pre-installed. • Your exhaust ducting (not included) is made of rigid metal or semi-rigid metal. See Duct requirements on page 16. • You have a 3/8" gas dryer gas line (if you are installing a gas dryer) that meets all national and local codes. Step-by-step instructions Note: If a gas dryer is being installed, you will need to call a licensed professional to do the installation. Step 1: Make sure that the floor is a solid, level surface • Use a level to make sure that the floor where you are installing your dryer is level. This helps minimize vibration, noise, and unwanted movement. Note: If the front of the dryer is higher than the rear by more than one degree, it may take longer to dry small loads. You can adjust the dryer feet to level your dryer (Step 3: Connect the exhaust ducting on page 23). Step 2: Move your dryer to the location you selected • Move your dryer to the location you selected, but do not push your dryer all the way back into the location. You need to connect the power cord and ducting before you move your dryer into its final position. Tip: For information about space requirements for a side-by-side installation, see Installing your dryer and washer side-by-side on page 13. 22 www.insigniaproducts.com