Insignia NS-TWM41WH8A User Manual - Page 16

INSTALLATION INSTRUCTIONS Installing your washer Tools you will need Pliers Phillips screwdriver Level Flat-head screwdriver Wrench Washer inlet hoses Step-by-Step instructions Step 1: Select a location Before you install your washer, make sure that the location: • Is a hard, level surface without carpeting or soft flooring that can obstruct ventilation. • Is away from direct sunlight. • Has adequate ventilation. • Is not exposed to freezing temperatures (32° F or 0° C). • Is away from heat sources such as oil or gas. • Has enough space so that the washer does not rest on its power cord. Step 2: Connect the water hoses Note The water supply hoses are not supplied with your washer and must be purchased separately. Caution • Use new water supply hoses. Using old hoses can result in leakage or overflow that can damage your property. • Do not connect multiple water supply hoses together to increase the length of the hose. Hoses connected this way can leak and cause electrical shock. If a hose is too short, replace the hose with a longer, high-pressure hose. 1 Make sure that there are rubber washers inside the fittings at both ends of each new water hose. Installing the water supply hoses without rubber washers can cause water leakage. Fitting Rubber washer 16 www.insigniaproducts.com