Insignia NS-TWM41WH8A User Manual - Page 22

INSTALLATION INSTRUCTIONS 3 If your washer is not level, carefully tilt your washer just enough to adjust the leveling feet on the bottom front of your washer. Extend the feet only as much as is necessary. If the feet are extended too much, your washer may vibrate. Level Loosen Lock Step 5: Power your washer Plug the power cord into a well-grounded, 3-prong, 120 Volt 60Hz approved electrical outlet, protected by a 15-amp fuse or comparable circuit breaker. Your washer is grounded through the third prong of the power cord. Step 6: Run a test cycle Run a test cycle to make sure that your washer is properly installed. 1 Load about 6 pounds (2.7 kg) of laundry into the tub. 2 Press the /Power button to turn on your washer. 3 Turn the cycle selector to select the Rinse & Spin cycle. 4 Press the /Start Pause button to start the test cycle. Your washer should not rock or vibrate excessively when water fills the tub, or when washing or spinning. The washer should drain well during the spin cycle. Caution • If you detect any water leaks while the washer is filling or draining, check the water connections. See Step 2: Connect the water hoses on page 16 or Step 3: Connect the drain hose on page 19. • If the washer rocks and/or vibrates excessively, level it again. See Step 4: Level your washer on page 21. 22 www.insigniaproducts.com